Prosoft-technology 3170-MBS Bedienungsanleitung PDF herunterladen (Seite 14)

Module Configuration and Installation 3170-MBS ♦ Flex Platform

User Manual Modbus Slave Interface Module

Page 14 of 55 ProSoft Technology, Inc.

October 27, 2010

3.1 Mounting on a DIN-rail before installing the terminal base units

1 Position the Modbus adapter module A on a 35 X 7.5mm DIN-rail B

(Rockwell Automation pt. no. 199-DR1: 46277-3; EN 50022) at a slight angle.

2 Hook the lip on the rear of the adapter (A) onto the top of the DIN-rail (B),

and rotate the adapter module onto the rail.

3 Press the adapter module down onto the DIN-rail until flush. Locking tab (C)

will snap into position and lock the adapter module to the DIN-rail.

4 If the adapter module does not lock in place, use a screwdriver or similar

device to move the locking tab down while pressing the adapter module flush

onto the DIN-rail and release the locking tab to lock the adapter module in

place. If necessary, push up on the locking tab to lock.

5 Connect the adapter wiring as shown under "Wiring" later in this document.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 54 55

Keine Kommentare

Prosoft-technology 3170-MBS Bedienungsanleitung Seite 14