ProSoft Technology inRA-x ILX34-AENWG Einstellungsanleitung PDF herunterladen (Seite 17)

Procedures ILX34-AENWG ♦ POINT I/O Platform

Setup Guide Wireless Point I/O Adapter

ProSoft Technology, Inc. Page 17 of 79

July 31, 2009

3.2.2 Install the Wireless Point I/O Adapter on the DIN-rail

Warning: You must follow all safety instructions when installing this or any other electronic

devices. Failure to follow safety procedures could result in damage to hardware or data, or even

serious injury or death to personnel. Refer to the documentation for each device you plan to

connect to verify that suitable safety procedures are in place before installing or servicing the

device.

1 Position the adapter vertically above the DIN-rail.

2 Press down firmly to install the adapter on the DIN-rail, and then turn the

orange screw to lock the adaptor onto the DIN-rail.

Warning: If you connect or disconnect the Ethernet cable with power applied to this module or any

device on the network, an electrical arc can occur. This could cause an explosion in hazardous

location installations.

Be sure that power is removed or the area is nonhazardous before proceeding.

3 Slide the safety end cap up to remove. This exposes the backplane and

power interconnections.

Caution: Do not discard the end cap. Use this end cap to cover the exposed interconnections on

the last mounting base on the DIN-rail. Failure to do so could result in equipment damage or injury

from electric shock.

Important: You must use series C POINT I/O modules with the ILX34-AENWG adapter. Series A

or B POINT I/O modules will not work with this adapter.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 78 79

Keine Kommentare

ProSoft Technology inRA-x ILX34-AENWG Einstellungsanleitung Seite 17