Prosoft-technology AN-X-AMX Bedienungsanleitung PDF herunterladen (Seite 17)

AN-X-DCSLOG Page 13

TagFile

The tag file contains the name of the file that contains the data to be logged: the tag

names for the points and their addresses (drop, register and, for Boolean data, the bit).

The contents of the tag definition file are described below.

Example

The following configuration file configures two AN-X-DCSLOG modules, one at IP

address 192.168.0.9 and the other at IP address 192.168.0.10

DeviceName,AmxLog9

ImportPath,c:\InSQL\DATA\DataImport\Fastload

DeviceIp,192.168.0.9

RefreshMs,60000

TagFile,DcsLog1.csv

DeviceName,AmxLog10

ImportPath,c:\InSQL\DATA\DataImport\Fastload

DeviceIp,192.168.0.10

RefreshMs,60000

TagFile,DcsLog2.csv

If you change the configuration file, you must stop and restart the logger service, either

from the command line or from the Control Panel.

Tag Definition File

The tag definition file is a comma separated variable (CSV) file that defines the points to

be logged. Each line defines one point. Each line consists of:

• tagname, up to 32 characters

• drop number, 0 to 55

• register, 0 to 63

• bit, 0 to 15

• type, WORD or BOOLEAN

Fields are separated by commas.

For drop 0, only registers 32-39 are valid.

The bit number is required only for BOOLEAN data and is ignored for WORD data.

You cannot create tags that have the same combination of drop and register. For

example, you cannot create a WORD tag for drop 1, register 32, and also create tags for

BOOLEAN tags using bits in drop 1, register 32.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Keine Kommentare

Prosoft-technology AN-X-AMX Bedienungsanleitung Seite 17