Prosoft-technology AN-X-AMX Bedienungsanleitung PDF herunterladen (Seite 22)

Page

AN-X-DCSNet2 November 2011

Using the AutoMax Programming Software

Any computer with Ethernet access can use an AN-X-DCSNet module to

connect to an AutoMax processor over DCSNet.

IMPORTANT!

The Virtual Device Driver runs under Windows XP or Windows 7 but

does not run under Windows Vista.

The following instructions assume that:

• AN-X has been configured and is active on the Ethernet network

• AN-X has been connected to the DCS network

• the AN-X DCS drop number and drop depth have been assigned

(see page 48)

To use AN-X-DCSNet with the AutoMax Programming Executive, you

must complete the following steps:

1. Install and configure the Virtual Device Driver (VDD)

2. Configure the programming software to use AN-X

Requirements

• Virtual Device Driver (VDD) version 3.1.0.4 or above, available on

the AN-X distribution CD

• AutoMax Programming Executive 3.9 or 4.3 or above

Installing and Configuring the VDD

1. Install the virtual device driver. Insert the AN-X distribution CD

that contains the Virtual Device Driver and install it.

2. Run the Control Panel Applet (Start/Control Panel/QTS PC Link

Card Configuration and set the Port Address and Memory Address.

You can leave them at their default values.

3. Check Enable AN-X-DCSNet Link

4. Enter the IP address of the AN-X in the AN-X IP Address field. If

you do not know the IP address, use Utilities/Locate All AN-X

Modules in AnxInit (see page 37) to find it.

5. Click OK.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Keine Kommentare

Prosoft-technology AN-X-AMX Bedienungsanleitung Seite 22